CLIFFORD 50x - Manual (Page 19)

EX AM PLE 1: Turn on AutoArm & Lock
When the system AutoArms (see page 9), it does not normally lock the doors to ensure
that you cannot accidentally lock the keys inside the vehicle. To enable this feature,
you’ll note that “AutoArm & Lock” is in column 3, row 2 of the table on pages 19-20.
The “
off ” in bold type indicates the factory setting. The following example will turn on
AutoArm & Lock.
1. To enter program mode, turn on the ignition, enter your valet code (as noted on page
10), then hold the switch in its momentary position until you hear a chirp.
2. Select column 3 by pressing the latched side and then returning the switch to its
centre position three times, then wait for the three chirps to confirm column 3. To
select row 2, press momentary two times (you’ll hear a chirp each time you press
the momentary side).
3. After a brief pause, you’ll hear two chirps to confirm that AutoArm & Lock is
now on.
4. Turn the ignition off. You’ll hear 3 chirps, confirming automatic exit from the
program mode, and you’re done!
If you make an error, just turn off the ignition and start again. To turn AutoArm &
Lock back off, just repeat steps 1–4. In step 3, you’ll hear one chirps to confirm that
the feature has been turned back off. Remember, one chirp = off, two chirps = on.
NOTE: You have 10 seconds to enter the row number after selecting the column. If you wait
too long, the system jumps back to the “Feature Select” position (this is indicated with 3
chirps). If you wait another 60 seconds, the system will exit program mode (this allows you
to make programming changes even whilst you’re driving). In Example 2 below, you’ll
learn how easy it is to change the settings of several different features in just one
session, without having to repeatedly turn the ignition on and off:
EX AM PLE 2: Turn off AutoLock and Aut oUn Lock, then turn on Qui etChirps:
This time, we will change the settings of three different features in just one programming
session: We will turn off both the AutoLock and AutoUnLock features (see page 12), as
well as turn on the QuietChirps feature (see page 15). Here’s all you have to do:
1. Enter program mode as previously noted (ignition on, enter your valet code, then
press the momentary side until you here a chirp).
2. Since AutoLock is in column 2, row 1 of the Table, you will have to enter the
latched side twice and the momentary side once. Therefore, move the switch to
latched, centre, latched, centre. Wait for the two chirps to confirm the selection of
column 2. Within 10 seconds, press and release the momentary side of the switch
once (you will hear a chirp when you press it). After a brief pause, you’ll hear 1
chirp to confirm that AutoLock is now off.
3. Since AutoUnLock is in column 2, row 2 and is in the same column as you just
entered for AutoLock, there is no need in this case to again select column 2.
Therefore, you can go right away to the row selection (momentary side of the switch).
Now, within 10 seconds, press the momentary side two times to jump to row 2.
After a brief pause, you’ll hear 1 chirp to confirm that AutoUnLock is now off.
4. Note that the QuietChirps feature is in the same column 2, row 5. Simply press the
momentary side 5 times.. After a brief pause, you’ll hear two chirps to confirm that
the QuietChirps feature is now on.
5. To exit the program mode, turn the ignition off. You’ll hear 3 chirps to confirm
program mode exit.
17
con tin ued . . .