Installation – Panasonic PANASYNC E70G TX-D7F21 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
^ Connecting Procedures
Turn off your computer.
Connect the signal and power connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS / 2 or PC / AT compatible models
CEE-22-connector
© Connect the supplied 15 pin mini D-Sub cable to the monitor’s Port A.
Then connect the other end of the supplied 15 pin mini D-Sub cable to the computers
corresponding 15 pin mini D-Sub video connector.
® First connect the supplied AC power cord to the CEE-22 connector on the rear of the monitor.
Then connect the other end of the AC power cord to a grounded power outlet.
B. Apple computer
© Connect the supplied 15 pin mini D-Sub cable
to the monitor’s Port A.
Then connect the other end of the supplied 15
pin mini D-Sub cable to a UNIMAC-82D MAC
adapter and the other end of the MAC .adapter
the computers to the computer’s corresponding
15 pin mini D-Sub video connector.
® First connect the supplied AC power cord to
the CEE-22 connector on the rear of the
monitor. Then connect the other end of the AC
power cord to a grounded power outlet.
Panasonic MAC adapter
If you need an adapter and one is not provided by your dealer,
call 1-800 PANASYS {1-800-726-2797).
— Caution:------------------------------------------------------------------------------------------------------------------
To prevent the cable from coming loose, the cable connectors must be securely fastened with screws.
^ Connection of AC Power Supply
If the AC power supply voltage is in the range 100 to 240 V, either 50 Hz or 60 Hz frequency can be used.
There is no AC 100 V / 240 V selector switch as selection is automatic.
* •
— Precaution:-----------------------------------------------------------------------------------------------------
• In order to use the display unit safely, use a power cord that is properly grounded.
• AC plug cords for the following countries must be used as follows:
U.S.A.............. UL
Canada........... CSA
For use in other countries, make sure that the AC cord meets the safety standards of each country.