Panasonic WV-7230D - Manual (Page 7)

TYPICAL SYSTEM CONNECTIONS
Mounting Bracket _
wv-7030
r
Pre-wired cable
WV-CA50
Indoor Receiver
WV-RC100
TTX
AC 24V 60Hz
System Controller
WV-CUZ54
Coax. Cable
<3
EB
0000
»
n 3 à
Coax. Cable
Monitor
AC 120V 60Hz
CONNECTIONS
CAUTION:
• The following connection should be made by qualified
service personnel or system installers.
• Make all connections with the power turned OFF.
• Avoid shorting the terminals, as this may blow a fuse.
If the installation is to be upside-down, the Pan Left-Right
and Tilt Up-Down directions will be reversed. This must be
considered when the wiring is done.
In this case, replace 1 and 2 pins of CN1 and CN2.
If the Pre-wired Cable WV-CA50 is used, replace them using
with MOLEX brand tool 57031-6000.
A. Wiring for Pan/Tllt and Motorized Zoom, Focus, Iris
Control
Control Voltage Control Current
ZOOM TELE -6VDC
WIDE -F6V DC
FOCUS NEAR -6VDC Less than 100 mA
FAR -fe v o c
IRIS OPEN -6VDC
CLOSE -fe v D C
B. The Video and Exit Sync. Terminal Board.
1. Wiring precautions:
• Do not bend coaxial cable into a curve who radius
is smaller than 10 times diameter.
• Never staple the cable - not even with circuì
staples.
• Never crush or pinch the cable.
All these will change the impedance of the cable and cause
poor picture quality.
2. Use the following conditions Cable.
Impedance: 75fì
Diameter: <f>S mm or less
Example: RG - 59/U (BELDEN 9259}
3. Wiring:
• Prepare coaxial cable as shown as below.
Fold back
• Connect as follows.
1 Clamp the coaxial cable with Cable Clamp.
2 Fold back the shield
3 Connect the inner conductor.
When using a camera with motorized zoom, focus and
iris, these connections should be made.
Note: Lens control cable should be approx. 39'
to allow sufficient room for PaaTilt.
-
6
-