Panasonic KX-F160 - Manual (Page 106)

T roubleshooting
General corrective measures
GENERAL
PROBLEM CAUSE & REMEDY
1 cannot transmit or receive a
document or cannot taik.
The line cords are connected incorrectly or not
connected.
—Confirm the connections (see page 1-9).
The unit does not operate properly. —Turn the POWER switch off, then turn it on again
(see page 1-15).
The ALARM indicator lights. The BACK LID OPEN cover of the unit is open.
—Close it firmly.
The unit does not ring. The RINGER volume selector is set to the OFF
position.
—Set the RINGER volume selector to the HIGH or
LOW position (see page 1-14).
TRANSMISSION
PROBLEM CAUSE & REMEDY
The ALARM indicator hashes after
transmission. A transmission error has occurred.
—Try again (see page 2-4).
The ALARM indicator iights during
transmission. A document more than 600 mm (23W') is being
transmitted.
—Divide the document so that the length can be
shorter than 600 mm (23W') (see page 2-2).
A document causes a jam.
—Remove it, then try again (see page 6-5).
The unit has been connected to a line that has
special telephone services, such as call waiting.
—Connect the unit to a line that does not have
such services.
The other party compiains that
ietters on the document are distorted.
If your line has special telephone services such as
call waiting, the service may have been activated
during the fax reception.
—Connect the unit to a line that does not have
such services.
Another telephone connected to the same line as
your unit is connected is hung off.
—Hang up and try again.
The other party complains that a
dirty pattern or black lines appear on
the received documents. The glass and rollers inside the document feeder
unit are dirty.
—Clean them (see page 6-9).
The unit does not feed the document
properiy.
The rollers inside the unit are dirty.
—Clean them (see page 6-9).
6-2