Panasonic WV-BP120 - Manual (Page 7)

(1) Lens (Option)
See pages 9, 10, 11 and 12 for details on lens
selection,
(2) Flange-back Adjusting Ring
This ring is used to adjust the back focal length or
picture focus by rotating this ring to clockwise, for
C-mount lens or counterclockwise for special C-
mount (CS-mount) lens.
Caution:
1. Always set this ring to fully clockwise before
mounting the lens.
2. Do not turn this ring too much to counterclock­
wise when the C-mount lens is mounted as
this could damage the inner glass and CCD
image sensor.
(3) Camera Mounting Screw Hoie
This threaded hole (1/4" - 20) is used to mount the
camera onto a mounting bracket or tripod.
(4) Auto Iris Lens Connector
This 4-pin female connector supplies the power
and either video signal or DC control signal to the
auto iris lens.
A 4-pin male connector, which can be mated with
the camera's female connector, is supplied as a
standard accessory {Pari No. YFE4191J100).
This male connector can be installed on lenses
which have incompatible type connector.
See page 13 for installation details,
(5) Lens Selection Switch (ALC (DC/VIDEO)), ELC
This switch is used to select the supplied auto iris
control signal to the lens from the Auto iris lens
Connector.
DC:
Choose this position when the auto iris control
lens requiring DC control signal such as WV-
LA2.8,
W\/-LA4R5C3A, WV-LA6B2, WV-
LA9C3A, WV-LZ61/10, WV-LA12B2, WV-LA18,
WV-LA36, WV-LA4510, WV-LA608, WV-
LA1208, WV-LZ81 /6A, WV-LZ81 /10, WV-
LZ83/6, is mounted on the camera,
VIDEO:
Choose this position when the auto iris control
lens requiring video signal such as WV-LA8B,
WV-LA16B, WV-LA25B, WV-LA50B, is mount­
ed on the camera.
-5-