Panasonic CQ-DFX883U - Manual (Page 50)

Installation Guide
A\ WARNING
This installation information is de­
signed for experienced installers and is
not intended for non-technical individu­
als. It does not contain warnings or cau­
tions of potential dangers involved in
attempting to install this product.
Any attempt to install this product in a
motor car by anyone other than quali­
fied installer could cause damage to the
electrical system and could result in se­
rious personal injury or death.
□ Installation Hardware
No. Mem Diagram QTy
© Mounting collar 1
Hex. nut (5 mm0) 1
CD
Rear support strap 1
0
Tapping screw
(5 mm0x16 mm)
1
0
Mounting bolt (5 mm0) 1
© Power connector 1
cz)
Removable face plate
case
1
0
Trim plate 1
® Lock cancel plate 2
□ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The in­
structions in these pages will guide you through the
remaining steps:
(Please refer to the “WARNING” statement
above.)
• Identify and label the car wires. .
• Connect the car wires to the wires of the power
connector.
• Install the unit in the dashboard.
• Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution:
• This unit operates with a 12 V DC negative
ground auto battery system only. Do not at­
tempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the items
which are packed with your unit.
• Warranty Card...Fill this out promptly.
• Panasonic Servicenter List for Service Directory
...Keep for future reference in case the product
needs servicing.
• Installation Hardware...Needed for in-dash in­
stallation.
□ Required Tools
You’ll need a screwdriver, a 1.5 V AA battery, and
the following:
12 V DC Electrical Side-cut
Test bulb tape pliers
□ Dashboard Specifications
Thickness Min. W {4.75 mm)
Max. Vzf (5.56 mm)
IJ 23 / 3 )" (53 mm)
75 / 32 " (182 mm)
50
CQ-DFX883U