CyberData Part #010861 930106D - Manual (Page 25)

Installing the VoIP Loudspeaker Amplifier
Configure the Loudspeaker Amplifier Parameters
VoIP Loudspeaker Amplifier Operations Guide 930106D CyberData Corporation
19
3. After changing the parameters, click Save Settings.
2.3.4 Configure the SIP Parameters
1. Click SIP Setup to open the SIP Setup page ( Figure 2-12 ).
Note For specific server configurations, go to the following URL:
http://www.CyberData.net/support/voip
RTFM Announcement a Enable/Disable the speaker tone (beep) and audio
associated with the RTFM switch.
Click on this button to save your configuration settings.
Changing a parameter that has an asterisk next to it will
cause a system reboot when saved.
Click on this button to do an audio test. Generates a voice
message for testing the speaker audio quality and volume.
Link to the Network Setup page.
Link to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Upgrade Firmware page.
Link to the Home Page page.
a.If you select No for RTFM Announcement, you will not hear a beep or associated RTFM audio.
However, the return to default settings function remains active. If you wish to return to default
settings, hold the RTFM button at least 20 seconds, then release the button.
Table 2-10. Loudspeaker Amplifier Setup Parameters
Web Page Item Description