Panasonic SL-PD347 User Manual
Panasonic, Sl-pd347, Compact disc changer
Advertising
Table of contents
Document Outline
- Panasonic
- RQT1959-L
- CAUTION!
- ■ Use a standard AC wall outlet
- ■ Grasp the plug when disconnecting the power supply cord
- ■ Place the unit where it will be well ventilated
- ■ Avoid places such as the following:
- ■ Be sure to place the unit on a flat, level surface
- ■ Never attempt to repair nor reconstruct this unit
- ■ If water is spilled on the unit
- ■ Avoid spray-type insecticides
- ■ Never use alcohol or paint thinner
- ■ Disconnect the power supply cord if the unit will not be used for a long time
- ■ If trouble occurs
- Supplied accessories
- Connections
- Display section
- ® Disc indicators ( <i> ~ <5> )
- 1 Press POWER to switch on the power.
- 2 Press OPEN/CLOSE to open the loading drawer.
- 3 Load the disc(s) on the disc tray(s).
- 4 Press OPEN/CLOSE again to close the loading drawer.
- 5 Press PLAY.
- Before beginning, follow steps 1-4 of “Basic Operating Procedure” on page 7.
- 1 Press DISC SKIP to select the desired disc.
- 2 Press PLAY to start.
- ■ To exchange discs during play
- ■ To temporarily stop play Press PAUSE.
- Before beginning, foilow steps 1-4 of “Basic Operating Procedure” on page 7.
- 1 Press the desired disc button (1 -5).
- 2 Press SKIP to seiect the track number.
- Before beginning, foliow steps 1-4 of “Basic Operating Procedure” on page 7.
- 1 In the stop mode, press PROGRAM MODE to iiiuminate the program play indicator.
- 2 Press the desired disc button (1-5).
- Press SKiP to seiect the track number.
- 4 Press PROGRAM MODE.
- 5 Repeat steps 2, 3 and 4 until you have completed the desired entry.
- 6 Press PLAY to start play.
- To change to the other play mode keeping the programmed contents
- To cancel program mode
- & Press PROGRAM MODE twice.
- Before beginning, follow steps 1-4 of “Basic Operating Procedure” on page 7.
- 1 In the stop mode, press PROGRAM MODE to illuminate the delete play indicator.
- 2 Press the disc button (1 -5).
- Press SKIP to select the track number.
- 4 Press PROGRAM MODE.
- 5 Repeat steps 2, 3 and 4 until you have completed the desired entry.
- 6 Press to start play.
- 1 Press STOP during play.
- 2 Press PROGRAM MODE.
- 3 Start the desired play (except program play).
- Press STOP In the delete mode.
- To cancel delete mode
- One disc random play
- Full random play
- Before beginning, follow steps 1-4 of ‘‘Basic Operating Procedure” on page 7.
- Press RANDOM MODE so that the play mode indicator points to FULL.
- ■ To cancel full random play mode
- Press STOP.
- Before beginning, follow steps 1-4 of "Basic Operating Procedure" on page 7.
- Press SPIRAL.
- Press SPIRAL again.
- ID scan function
- Skip function
- Time mode selection
- (flog®