Panasonic CCTV CAMERA WV-BP102 - Manual (Page 10)

Video Cable
1. It is recommended to use a video monitor whose
resolution is at least equal to the camera’s.
Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
It is recommended to use 75-ohm coaxial cable.
Always set the last monitor's termination switch
to 75 ohms, and set the termination switches
of intermediate monitors to high impedance (Hi-Z)
position.
Table 1
Monitor Monitor
The maximum extensible coaxial cable length
between the camera and the monitor is shown
in the table 1. Since cable quality varies among
manufactures,
verify video quality before final
installation if maximum lengths are to be used.
Type of
coaxial cable
RG-59/U
(3C-2V)
BG-6U
(6C-2V)
RG-11/U
{7C-2V)
RG-15/U
(10C-2V)
Recommended
maximum ■
cable lengh
(ft) 825 1,650 1,980 2,640
(m) 250 500 600 800
Note;
Recommended maximum cable length between this
camera and WV-PS11A/ WV-PS104B is also same
as the Table 1.
3. Wiring precautions :
• Do not bend coaxial cable into a curve whose radius
is smaller than 10 times the cables diameter.
• Never staple the cable-not even with circular
staples. Mismatching will occur.
• Never crush or pinch the cable.
All of these will change the impedance of the cable
and cause poor picture quality.
- 8 -