Recalling stored measurement values, Shown, Press – Panasonic EW3152 User Manual
Page 20: Q press
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECALLING STORED MEASUREMENT VALUES
8/
SYS
DIA.
/5
I.
n .
I
CD 38
1
Press
the M/R (memory/recall) button for the
person whose data you want to recall.
The average of all measured values In memory will be
shown.
• Eia mark will be shown at the bottom of the display.
• For example, if 90 measured values are stored, the
average of the 90 measurements will be shown. (If
only 1 measurement is stored, the fJTl mark will not
be shown.)
• The blood pressure indicator lamps will light (for
approximately 6 seconds).
Q Press
the M/R (memory/recall) button again.
Each time you press the M/R (memory/recall)
button, the previously stored measurement values
will be
shown
In order, starting with the newest
data.
• The blood pressure Indicator lamps will light (for
approximately 6 seconds).
• If no measurement values are stored, no value will be
shown.
Press the M/R (memory/recall) button lightly for only a
short time. If you hold the button pressed for
approximately 3 seconds or longer, all data in memory
will be erased, so please be careful.
3
To cancel measurement value recall,
press the On/Off Start button.
• If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 30 seconds.
20