Panasonic RQ SW44V - Manual (Page 3)

TAPE
"eh
Auto reverse
Play will continue, looping fon^ard and re-
versa sides, until [■] Is pressed.
Notes:
•Before playback, be sure to set [«AM/FM/
OFF] to “OFF".
•When closing the cassette holder, be sure
to push the cassette holder firmly against
the unit, and turn [OPEN LOCK] until it
locks.
•Do not open the cassette compartment
cover during tape operation.
• Between functions {during play, fast for­
ward or rewind), always press [■] first to
avoid jamming the tape.
•When the tape reaches the end after fast
forward or rewind, press [1] to release the
button.
• If you press [* *AM/FM/OFF] to switch on
the radio during tape operation, the but­
tons wilt not be released even though the
motor has stopped. Press [■] to release
the button.
RADIO
Concerning the hold function
This function prevents the unit from operat­
ing even if one of the front panel buttons is
pressed in error.
During hold state
If a button ts pressed.
™ , 8 B . /
- BiBia —
0
/ I N-----------------
To obtain better reception
FW!
How to receive an FM broadcast clearly
Set FM RECEPTION to NORMAL
When the FM reception is impaired, or there
is interterence from a powerful station, set it
to CITY.
AM;
When a station is tuned in.
FM
ea
Preset tuning
A total of 20 stations can be stored as
follows:
MODE 1: FM 1-5, AM 1-5
MODE 2: FM 1-5, AM 1-5
We recommend that you use MODE 1 for
daily use, and MODE 2 for travel.
■ Mode selection
Press and hold [»MODE] for more than
2 seconds.
"II"
(MODE 1) or
“S"
(MODE 2}
is shown on the display.
■ Memory presetting
1. Tune in the station to be stored.
2. Press and
hold one of
the memory
buttons {[
1
],
[2], [3], [4],
[5])for
about
2 seconds.
3 beeps can be heard
Memory
buttons
DQ I
Memory
P O. / ^ channel
To recall a preset station
Press a memory button ([1], [2], [3], [4], [5]).
•Release the button within 2 seconds.
When using overseas
Allocations need to be changed according to
the area.
Every time the following procedure is per­
formed, the allocation setting changes as
follows:
FM 0.2 MHz, AM 10 kHz*
(original setting)
FMO^I MHz, AM 10 kHz
1
FM0.05 MHz, AM 9 kHz-------
■ How to adjust the allocation
settings
1. Press and hold [»MODE] to select the
mode (MODE 1 or MODE 2).
2. While pressing [ВАТТ CHECK], press
and hold [» MODE] for about 3 seconds,
•The changed allocation settings (FM
and then AM) are displayed.
Note:
Converting the allocation erases the stations
previously stored in memory.
BASS XBS does not function for AM reception.
If you press
[XBS ON/OFF] during AM re­
ception, "E." is shown on the display,
XBS
Boosts the low frequency range.
• If distortion occurs, turn down the volume.