Panasonic CT-3268S - Manual (Page 5)

Installation
Television Location
This television is intended to be used with an optional stand or entertainment center. Consult your dealer for available
options.
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting may reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best
performance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you’ll need.
AC Power Supply Cord
WITH A RECEPTACLE OR OTHER OUTLET UNL
INSERTED TO PREVENT BLADE EXPOSURE.
Remote Control Battery Installation
Batteries: Use two “AA” batteries.
1. Remove the battery compartment cover on back
of the remote.
2. Install the batteries in the battery compartment.
(Polarity (+) or (-) must be correct.)
3. Reattach the battery cover.
Helpful Hints:
For frequent Remote Control users, replace old
batteries with Alkaline batteries for longer life.
Precaution on Battery Use
Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control
Transmitter.
Observe the Following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example: “Zinc Carbon”
with "Alkaline”).
4. Do not attempt to charge, short-circuit, disas­
semble, heat or burn used batteries.
5. Battery replacement is necessary when Remote
Control reacts sporadically or stops operating the
Receiver.
Helpful Hints:
Whenever you remove the batteries to replace
them,
you may need to reset the Remote Con­
trol Infrared Codes. We recommend that you
initially record the codes in the Infrared Remote
Codes for Specific Components section, prior to
settinq up the remote.______________________
- 5 -