Panasonic PT-51G40 - Manual (Page 16)

Cable Power Button
- The cable power
butian on the Remote Control has been designed to
operate selected brands of Cable Television Converter
boxes The proper cable television converter infra-red
code must be obtained prior to use (Please refer to
Programming the Universal Remote for programming
instructions ) The Remote Control TVA/CR/CABLE
switch should be in the CABLE position
NOTE. The CHANNEL UP and DOWN buttons on the
Remote may be used for selecting Cable Con­
verter box channels
CABLE
POWER
Located On Remote Control
Use In selsd CablB
Channsls aPtsr programming
Infra-red Cods
PIP
SWSp
Button
— Press the SWAP button
(when the PIP frame is displayed) to interchange what is
being viewed on the Mam Picture with that of the PIP
frame.
SWAP
cP
- Audio will be that of the Mam Picture
PIP Size Button
- Press the SIZE button (when
the PIP frame is displayed) to choose eitherthe large or
small PIP frame
PIP (Picture in Picture) Button
- This
feature allows monitoring one channel while watching
another when a second video source with a tuner is
connected (such as a VCR) to the television
NOTE. When the Main Picture is in Video mode with no
signal, the PIP will not operate properly
PIP Operation
1
Turn VCR ON and select a desired channel
2 Place the TVA/CR/CABLE switch on the Remote
Control into TV position
3 Press the PIP burton (television must be ON) The
PIP frame will appear at the position it was last
displayed The Mam Picture Video Source and PIP
Video Source will display on screen momentarily
Audio will be that of Main Picture
4 Press the PIP button again to cancel PICTURE IN
PICTURE feature (if desired)
NOTE; For PIP Video source connection, refer to the
PIP External Video and Antenna Connections
section
Helpful Hints:
- The TV/VCR/CABLE Switch should be m the TV
position (LEFT) before operating PIP buttons
- 1 6 -