Av1 select operation on the remote controller, Note, Basic operation on the remote controller – Panasonic TC-29V1Z User Manual
Page 21: Helpful hint, I (11, Connection
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connection
AV1 Select Operation on the Remote Controller
1
.
TV/AV
Push the “TV/AV” Button on the Remote Controller.
Then last selected AV mode will be displayed on the screen.
2
.
AV SELECT
Select the “AV1” mode by pushing this button, you can sequentially
select three AV modes, as shown below.
Note:
When the S-Video cable is
connected to AV1 (S-Video)
Terminal, the “S-Video” symbol will
be displayed on the screen as
shown left.
3.
PLAY
to
Push the “PLAY” Button on the Connected Equipment.
Helpful Hint
SYSTEM
System Button
I (11
On the AV mode, If the clear picture cannot be obtained even when the
T3
AV signal is received, push the System Button repeatedly until the
optimum image can be produced.
F^r operation details, refer to “System Select Operation” on page 49.
Note:
(1) When AV mode (AV1, AV2 and AV3) is selected and the selected AV mode has no AV signal, the
On-screen will be changed from Black out picture to Colour back picture.
(2) When the played back picture may be unstable, then by pushing “Play” Button you can obtain
the clear picture.
(3) When the S-Video cable is connected to S-Video Terminal, Input Terminal will be changed from
Video to S-Video Terminal.
(4) When the Monaural VCR is played back. Connect the Monaural Audio cable to the Audio “L”
(Left) Terminal.
21