Panasonic WV-BP100 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(1) Auto Iris Lens Connector
This 4-pin female connector supplies the power and
either video signal or DC control signal to the auto
iris lens.
A 4-pin male connector, which can be mated with
the camera’s female connector, is supplied as a
standard accessory (Part No. YFE4191J100).
This male connector can be installed on lenses
which have incompatible type connector.
See page 13 for installation details.
.(2) Camera Mounting Screw Hole
This threaded hole (1/4" - 20) is used to mount the
camera onto a mounting bracket or tripod.
(3)
Flange-back Adjusting Ring
This ring is used to adjust the back focal length
or picture focus by rotating this ring to clockwise
for C-mount lens or counterclockwise for special
C-mount (CS-mount) lens.
Cautions;
1.
Always set this ring to fully clockwise before
mounting the lens.
2.
Do
not
turn
this
ring
too
much
to
counterclockwise when the C-mount lens is
mounted as this could damage the inner glass
and CCD image sensor.
(4)
Lens (Option)
See pages 9, 10, 11 and 12 for details on lens
selection.
(5)
Lens Selection Switch (AUTO IRIS, DC/VIDEO)
This switch is used to select the supplied auto iris
control signal to the lens from the Auto iris lens
Connector (1).
DC:
Choose
this
position
when
the
auto
iris
control
lens
requiring
DC
control
signal
'such as WV-UV2.8, WV-U\4R5G3, WV-LA6B2,
WV-LA9C3,
WV-LA12B2,
WV-LA18,
WV-LA36,
WV-LA4510,
WV-LA608,
WV-LA1208,
WV-L281/6A,
WV-LZ81/10,
WV-LZ83/6,
is
mounted on the camera.
VIDEO :
Choose
this
position
when
the
auto
iris
control
lens
requiring
video signal
such as
WV-LA8B,
WV-LA16B,
WV-LA25B,
WV-LA50B,
is mounted on the camera.
- 5 -