Panasonic TX-2103MA - Manual (Page 6)

■ Signal Connection
The signal connector should be connected as follows according to the type of signal connector
and the signaling system used.
A. When the Signal Connector is 15 Pin Mini D-Sub (In the Case of PS/2 or compatible)
Connect the signal cable to the 15 pin mini D-sub connector of the display unit.
Push the signal connector select switch upwards.
B. When the Signal Connector is a 15 pin D-Sub Connector (In the case of MAC-II)
Convert the 15 pin D-sub connector of the MAC-II to a 15 pin mini D-sub connector using a con­
version connector, and then connect it to the 15 pin mini D-sub connector of the display unit.
Push the signal connector select switch upwards.
Check if the change-over connector is connected as shown in the following figure.
Pin Arrangement of 15 Pin
Mini D-Sub Connector
p fi 3 fi
5 9
Pin Arrangement of 15 pin
D-Sub Connector
Pin No. Signal name
1 Red video signal
2 Green video signal
3 Blue video signal
4 Ground
5 Space No connection
6 Ground for red video signal
7 Ground for green video signal
8 Ground for blue video signal
9 Space No connection
10 Ground
11 Ground
12 Space No connection
13 Horizontal synchronizing signal
14 Vertical synchronizing signal
15 Space No connection
r
Pin No. Signal Connector
1 Ground for red video signal
2 Red video signal
3 Composite synchronizing signal
4 Ground for composite synchronizing signal
5 Green video signal
6 Ground for green video signal
7 Space No connection
8 Space No connection
9 Blue video signal
10 Space No connection
11 Space No connection
12 Space No connection
13 Ground for blue video signal
14 Space No connection
15 Space No connection
C. When the Signal Connector is BNC Connector Signal Systems
Push the signal connector select switch downwards.
f
1
M
i 1 Ì
Signal connector select switch
Separate System
Connect the signal cables to RED, GREEN,
BLUE, H-SYNC AND V-SYNC connectors.
Composite System
Connect the signal cable to RED, GREEN, BLUE
and H-SYNC (H/V composite) connectors.
Sync On Green System
Connect the signal cable to RED, GREEN (sync
on green) and BLUE BNC connectors.
- 4 -