Hold operation, Release the hold condition, Set the function selector to *‘radio – Panasonic RQ-V180 User Manual
Page 9: Adjust the volume using the volume control, B fm mode selector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hold operation
Setting the hold switch to *‘HOLD” position will
hold the present condition, and reject the opera
tion of the front panel buttons.
This is useful to prevent unexpected operation.
(The hold indicator will appear on the display.)
Before operating the front panel button, be sure to
release the hold condition. (The hold indicator will
disappear.)
1. Release the hold condition.
2. Connect the included stereo earphones
to the headphones jack.
3. Set the function selector to *‘RADIO”.
The OPR/BATT indicator will illuminate and
the frequency display will appear.
4. Press the band select button to select the
desired radio band (FM or AM).
5. Press the + or - button to tune In your
favorite station.
The frequency display will change.
(AM step by 9 kHz, FM step by 0.05 MHz.)
When you listen to the FM broadcast, set the
FM mode selector to the proper position.
6. Adjust the volume using the volume con
trol.
To turn off the radio, set the function selector to
TAPE”.
B FM Mode Selector
To receive FM stereo broadcasts, set the FM
mode selector to “ST”. If reception is poor
(excessive noise), set to “MONO”. This will
reduce the noise and provide clear reception,
however, the broadcast will not be heard in
stereo.
•When receiving the FM stereo broadcasts, the
stereo indicator will appear.
- 9 -