Panasonic WZ-AD96 - Manual (Page 13)

G e t t i n g S t a r t e d
( 6) Clock Source Selection Button [CLOCK]
clock
. . . . . . . .
This button toggles the clock source selection either external or
internal. If EXT is selected, this unit synchronizes to the wordclock □ error
signal supplied to the rear panel. The respective indicator lights.
© Clock Source Selection Indicator [CRYSTAL EKT ERROR]
Crystal: Lights in green when the unit operates with internal
clock.
□
l~C AL I
EXT: Lights in green when the unit synchronizes to the external clock.
Error: Lights in red when an unlock or no input is detected in
the EXT setting, or for changing duration of internal frequency.
® Word Length Button [LENGTH]
For dither processing this button selects word length from among
24 bit, 20 bit or
16 bit, and the respective indicator lights.
LENGTH
l—J 24bit
aObit
I---- 1 )6bil
® Word Length Indicator [24 20 16]
Selected word length is displayed; 24-bit, 20-bit or 16-bit.
@ Reference Level Indicator [REF LEVEL -20 -18 -16 -14]
These indicators display the reference level (Unit: dDFS) set by the
DIP switch on the rear panel.
□
I SHIFT I
REF LVL
CZ] -14
IZZI -16
I I -ia
CZ] -20
{dB FS)
® Level Meter [ PEAK -6 REF -24 -42 -58, PEAK -2 -4 -8 -10 -20 -30]
AD9^ Only
A 10-point bar graph meter is provided for each channel in the meter section.
The meters display levels in the normal or zoom mode set by the METER
MODE LED button. The normal scale is put right side the each meter while
the zoom scale is placed at the left side adjacent to the meter section.
6ch A/D Converter WZ-AD96
In the normal mode the right side scale is referred.
PEAK, - 6, (-12), REF, -24, (-30, -36), -42, (-48), -54
In the zoom mode the left side scale is referred.
PEAK, (-1), -2, (-3), -4, (-5), -6,-10, -20, -30
Input Level Trimmer [LEVEL] AD96 Only
Use a screw driver to adjust the level.