Panasonic SL-PD6 - Manual (Page 5)

OPTICAL
coQ--------
□
III
O© ooo
© o©©
o ooo
Receiver
(not included)
Optical-fibre cable
not included)
This unit
R6, AA, UM-3
Remote control signal sensor
Transmission
window
About 7 meters in
front of the signal
sensor
Connections
Before making connections, be sure that this unit and all other
system components are turned off. Q
White (L)
Red (R)
Stereo connection cable (included)
___________ ___________^-OnS^
(For United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 3 BEFORE THE
FOLLOWING CONNECTIONS.
■
Although the figure shows the AC power supply cord being
connected to a household AC outlet, if the amplifier (or receiver) is
equipped with a AC outlet, connect the cord to that outlet.
Insertion of connector Q
Even when the connector is perfectly inserted, depending on the
type of inlet used, the front part of the connector may jut out as
shown in the drawing.
However there is no problem using the unit.
Digital connection Q
Remove the dust-protection cap and connect this unit to other
digital equipment with an optical fibre terminal, such as a receiver
or digital surround processor.
* Leave the cap attached when this terminal is not being used.
For your reference
If you have DTS format CDs, you can enjoy six channel playback
by connecting this unit to a receiver or digital surround processor
that has a DTS decoder.
Use only the optical fibre terminal when playing back DTS format
discs. DTS signals can only be correctly output through the digital
terminal. Connection through the stereo LINE OUT terminals will
result in noise and could possibly damage your speakers.
• DTS is a trademark of Digital Theater Systems, L.P.
[PtS^ring the rennoie control
SL-PD8 only
Battery installation
Check the { + ) and (-) sides.
IBI
Use of batteries
• Do not mix old and new batteries, or batteries of different types
(manganese and alkaline, etc.).
• Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
• If the remote control is not to be used for a long period of time,
remove the batteries and store them in a cool, dark place.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use rechargeable type batteries.
When you need to replace these batteries
Use two R6, AA, UM-3 or equivalent batteries.
Correct method of use III
Use the remote control within 60 degrees and within 7 meters (23
ft.) facing toward the unit.
Operation notes
Aim the remote control’s transmission window toward the unit’s
sensor. Avoid any obstacles.
Be sure the transmission window and the unit’s sensor are free
from dust. Excessive dust might affect performance.
Do not expose the remote control signal sensor to direct sunlight
or to the bright light of an inverter fluorescent light.
0)
s
o
CQ
To prevent damage
Never place heavy items on top of the unit.
Do not disassemble or reconstruct the unit.
Do not spill water or other liquids into the unit.
RQT475T