Cleaning secondary foam filter, Replacing hepa exhaust riter, Юшыёш|шшшмё1 – Panasonic MC-V7380 User Manual

Page 15: Limpieza del segundo filtro de goma espuma, Cambiar del filtro de escape hepa, Segundo fìltm de goma espuma, Cubierta, Filtro de, Hepa y el marco

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ЮШЫЁШ|ШШШМЁ1

Performing the following tasks will keep your new Panasonic vacuum cleaner operating at
peak performance levels and will ensure these high levels for years to come. Check the
BEFORE REQUESTING SERVICE section In this manual for recommendations on performing
some of these tasks to help solve various problems that may occur.

Siguiendo

/as /nsfrucc/ones dadas, se nueva

aspiradora Panasonic funcionará al nivel máximo y

continuará funcionando por mucho años en el ^turo. Lea la sección “Antes de pedir servido“ en este
manual para las recomendaciones para arreglar unos problemas que puedan ocurrir.

Cleaning Secondary Foam Filter

Limpieza del segundo filtro de goma espuma

Secondary

Foam Filter

Segundo fìltm

de goma espuma

The secondary foam filter protects the motor

El segundo fittro de goma espuma protege el motor

Check filter when Installing a new dust bag

Al instalar una nueva bolsa de polvo revise el filtro

If dirty, pull filter from bottom of dust compartment and

clean by rinsing in water

Si esté sudo, tire del filtro del fondo del
compartimento de polvo y limpíelo enjuagando con
agua

When dry, slide filter back into place

Cuando esté seco deslice el fíltre a su tugar

Ensure filter is fully inserted under plastic rib

projections

Asegúrese de que el filtro está instalado debajo de las lengüetas plásticas

Replacing HEPA Exhaust RIter

Cambiar del filtro de escape HEPA

The HEPA exhaust filter removes dirt from recirculated air

El filtro de

escape

HEPA quita el polvo del aire redclado

Check filter when Installing a new dust bag

Revise el filtro al Instalar una nueva bolsa de polvo

Dust

Cover

Cubierta

de polvo

ncrM

Exhaust Filter

and Frame

Filtro de

escape

HEPA y el marco

>~

If dirty, remove filter from bottom of the dust cover by pulling

straight up on retainers on frame. Lift one side at a time

Si esté sudo, quite el fíltre del tondo de la cubierta de polvo al tirar

hada arriba en las lengüetas del marco. Levante un lado y

después

el otro lado

Place new filter In dust cover DO NOT CLEAN WITH WATER*

Coloque el filtro nuevo en la cubierta de polvo No limpie con

agua*

Place filter in frame and install in dust cover, making sure

white side is facing up

Coloque el filtro en el marco y instale la cubierta de polvo asegurando de que el lado

¿Vaneo

hada arriba

*Filter cannot be cleaned and should be replaced at least once each year

*No se puede limpiar el filtro y se debe cambiarlo a lo menos una vez cada aсo

-

15

-

Advertising