Installation – Panasonic PanaSync S70 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
^Connecting Procedures
Turn off your computer.
Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS/2 or compatible models
Rear view
AC power cord
15-pin mini
D-sub cable
(D Connect the supplied signal cable to the
monitor’s port.
@ Connect the other end of this cable to the
a power outlet.
B. Apple computer
Use a UNIMAC-82D MAC adapter.
Panasonic MAC adapter
If you need an adapter and one is not provided by your dealer,
call 1-800 PANASYS (1-800-726-2797).
OI
UUU
m MAC adapter
To prevent the cable from coming loose,
the cable connectors must be securely
fastened with screws.
^Connection of AC Power Suppiy
If the AC power supply voltage is in the range 100 to 240V, either 50Hz or 60Hz frequency can be
used.
There is no AC100V/240V selector switch.
Precaution:
• In order to use the display unit safety, use a power cable that is properly grounded.
• AC plug cords for the following countries are supplied in the same package.
U.S.A... UL
Canada ... CSA
For use in other countries, make sure the AC cord meets the safety standards of each country.
— 5 —