Dubbing, Ag-5210 for playback, Ag-5210 for recording – Panasonic AG-5210 User Manual
Page 11: Operation, Auto off output ctl output
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTO OFF Output
CTL Output
If any trouble should occur, this unit is set to AUTO OFF.
At such a time, the unit stops automatically, and the REC
Lamp flashes. At the same time, signals are output from
the AUTO OFF OUT Connector on the rear panel. When
the Power Switch is set off, AUTO OFF is released.
The CTL signal to be recorded on the tape is output in
the form shown in the figure below. It can be used for
the tape travel count, etc.
OPEN
(Max. 12 V)
OV
OV at AUTO OFF
OPEN
(Max. 12V)
OV
Standard
speed: 33.35mm/s
Dubbing
Refer to the figure below for the connections which apply when using two VTRs for dubbing.
Audio Cable (phono)
AG-5210 for playback
• Memory Button: OFF
• Load the pre-recorded tape.
AG-5210 for recording
• Memory Button: OFF
• Load the unrecorded tape.
Operation
O
Press the PLAY Button on the playback VTR to start
playback.
® Press both the REC and PLAY Buttons on the record
ing VTR at the location where the dubbing is to begin,
and proceed with dubbing.
© To stop the dubbing, first press the STOP Button on
the recording VTR and then press the STOP Button
on the playback VTR.
• With 6-hour recording for dubbing purposes, use the unit
with the Fli-Fi REC Switch at the OFF position.
- 11 -