Panasonic CF-M34 series - Manual (Page 10)

First-time Operation
@ The cover is closed by inserting the hook at the right end (see illustration) into the
groove.
( 7 ) Close the cover using the arrow as a guide.
@ Lock the latch into place.
-------------------------------- r
Confirm that the latch lock is correctly in place. Should you decide to carry your
computer without the latch lock in place, the cover may open causing the battery
pack to fall out.
Connect your computer to a power outlet
©
Be sure the AC adapter is connected until completing Step 10 on page 13.
Handling the AC adapter
• Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections. j
• Use only the specified AC adapter with your computer. Using an AC adapter,
other than the one supplied might damage the battery and/or the computer.
• When the DC plug is not connected to the computer, disconnect the AC cord from*
your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of tliunder and light-
Latch
ning. Since this could adversely affect your computer, an uninterruptible power source-
^ (UPS) is highly recommended unless the battery pack is installed.________________ J
S open the display
0 Lift up the latch.
(0 Lift open the display.
Turn your computer on
Slide the power switch and hold it for approximately one second until the power indi­
cator (^^) turns on before releasing it.
Once the computer is powered oft', you must wait at least ten seconds before pow­
ering it on again.
X note ).
The power saving function is factory set, so if there is no input from a key, the
touch pad, the touchscreen or an external mouse (when one is connected) for a
certain interval of time, the power to the LCD and hard disk may be turned off.
The LCD will resume operation when the touch pad, touchscreen or an external
mouse (when one is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even
when an application software is being installed. In this case, because it is conceiv-
able that a selection dialog box will be shown, do not press C Space ) or ( Enter)
to attempt to resume from this condition as doing so may trigger a selection, but
instead, press a key unrelated to the direct triggering of a selection, like( Ctrl ) .
In addition, when the computer is left alone, it automatically enters the standby*
mode (G^ “Standby/Hibernation Functions”). The computer will resume
by sliding the power switch.
4Winddws>2000I standby or hibernation
10