Notice – Panasonic CS-1873KR User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Faults
Cause
Airflow does not begin
immediately during heating
operation.
• If the airflow begins before its temperature become warm, it will cause an
undesired cooling effect. In order to prevent this, the airflow will not begin until
it is sufficiently warm.
(The operation lamp will blink until the airflow begins.)
Operation stops for about 12
minutes during heating.
(The operation lamp blinks.)
• This is to thaw the frost which has accumulated on the outdoor unit (defrosting
operation). This will take no longer than about 12 minutes, so wait for
operation. (Frost accumulates on the outdoor unit when the outdoor
temperature is low and the humidity is high.)
Water comes out of the outdoor unit.
WARNING
(1) REMOVE POWER PLUG OR DISCONNECT FROM THE MAINS BEFORE SERVICING THIS APPLIANCE.
(2) THIS APPLIANCE MUST BE EARTHED.
IMPORTANT
1. WHEN THE POWER CORD IS CONNECTED TO THE MAINS THROUGH ALL-POLE SWITCH
(DISCONNECTING MEANS)
THERE MUST BE AN ALL-POLE SWITCH (DISCONNECTING MEANS) WITH MINIMUM 3 mm CONTACT
GAP IN THE FIXED INSTALLATION CIRCUIT.
2. WHEN THE POWER PLUG IS CONNECTED TO THE RECEPTACLE
The wires in this main lead are coloured in accordance with the following code:
Green-and-yellow:
Earth
Blue;
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows;
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the
letter E or by the earth symbol @ or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured
red.
NOTE
IF THE SUPPLY CORD ON THIS APPLIANCE IS DAMAGED, IT MUST BE REPLACED BY A SPECIAL CORD
OBTAINABLE AT AUTHORIZED SERVICE/PARTS CENTRES.
NOTICE
* Before installing the models, check with local
electric authority for approval.