Bogg, About moisture – Panasonic SL-PD1348 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of

Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.

Problem

Probable cause(s)

Suggested remedy

Changer will not play.

A disc(s) or other foreign object(s) has fallen
inside the changer.

•Open the loading drawer, and then remove the

object.

Moisture has collected in the changer.

•Switch on and allow the changer to dry out for

about one hour before using it.

The disc In the changer

does not play.

The disc is upside down.

•Make sure the label is facing upward.

The disc is dirty.

•Wipe the disc with a soft cloth.

The disc is scratched.

•Replace the disc with a new one.

The disc is warped.

The disc is not within specified standards.

Play stops before changing
to the next disc.

The loading drawer is open.

•Press the ^ OPEN/CLOSE button to close the

loading drawer.

A certain music passage
can’t be played correctly.

The disc is dirty.

•Wipe the disc with a soft cloth.

The disc is scratched.

•Replace the disc with a new one.

There is noise from the
tuner or disturbance on the
TV screen.

Caused by high-frequency signals from this
changer.

• Use the changer further away from the tuner or TV,
• If the tuner or TV's antenna is the indoor type, use

an outdoor one.

When program play is

started, an error message
(-E) appears on the display.

Play was started without a track being
programmed.

•Program a track.

An error message (-E)
appears on the display, and
the changer stops
operating.

The mechanism of the changer has been
improperly adjusted.

•Turn the unit off and then back on again.

However, if the loading drawer is fully open, take
out the compact disc(s) at the front position and
then turn the unit off and then back on again.

The loading drawer stops

in the middle of opening.

BOgg

When using the tuner with this changer;

If noise is excessive in the FM mode, turn off the power supply of this

changer.

u':

Y,'

■■ .V

Wipe this unit with a soft cloth.

if the surfaces are extremely dirty, wipe clean with a cloth which has

been dipped in a weak soap-and-water solution and wrung out
thoroughly, and then wipe again with a dry cloth.

•Do not use alcohol, thinners, etc.
•When using chemically treated cloths, refer to the explanations

provided with them.

About moisture

Moisture may form on the lens In the following cases...
•immediately after a heater has been turned on.
•In a steamy or very humid room.
•When the unit is suddenly moved from a cold environment to a

warm one.

If moisture forms inside this unit, it may not work properly. In this

case, turn the unit on and wait about one hour for the moisture to
evaporate.

15

Advertising