Before use, Parts identification, Charging adaptor – Panasonic ES7015 User Manual
Page 6: Charging
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water
tight shaver in the shower and clean
it in water. Treat yourself to wet iather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet/Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Charge the shaver for at ieast 8 hours
before using it for the first time or
when it has not been in use for more
than six months.
Parts identification
(see fig. 1)
@ Protective cap
(g) System outer foil
© System outer foil release but
tons
® Foil frame
© Inner blades
® Foil frame release buttons
© Switch lock button
® On/Off switch
(D-a
Recharge lamp/Charge sta
tus lamp (ES7015, ES7016)
®-b Battery capacity monitor/
Charge status lamp
(ES7017, ES7018)
® Trimmer
® Trimmer switch
© Charging adaptor holder
@ Charging adaptor
• Model ES7015:100-120V AC
•Model ES7016,
ES7017,
ES7018: 100-240V AC
(Automatic voltage conversion)
© Rotatable stand
Charging adaptor
(see fig. 1)
Lift the charging adaptor holder until
it clicks in when charging the shaver,
(see fig. 1(A))
(Restore the charging adaptor holder
when carrying the unit.) (see fig.
1(B))
Rotate the stand on the bottom of
the charging adaptor when you need
extra stability, (see fig. 1 (C))
Charging
(see fig. 2)
Place the charging adaptor upright
on a flat surface. Plug the adaptor
into an AC outlet.
In some areas, a special plug adap
tor may be required.
Switch the shaver to the “0 • charge"
position and place it upright into the
charging adaptor with the switch fac
ing toward the front.
The charge status lamp will glow red
when the shaver is placed on the
correct position. It will flicker red
when the charging is completed (see
fig. 2 (A)).
For ES7017 and ES7018, the bat
tery capacity monitor will display the
fully charged condition at the same
time (see fig. 2 (C)).
The system will turn off in about 10
minutes after the charging has been