Panasonic CW-1406BU - Manual (Page 5)

1 Power Supply
Set the Main Control Knob to the OFF position; confirm that the Power Supply Cord is connected to a proper AC outlet.
<115V, 60Hz>
2 Main Control Knob
Set Main Control Knob to desired position :
OFF - Stops all operations.
FAN - Fan only operation without cooling.
LOW COOL - Air cooling operation at tow fan speed.
MED COOL - Air cooling operation at medium fan speed.
HIGH COOL - Air cooling operation at high fan speed.
Note : To resume cooling operation, wait 3-5 minutes before restart.
3 Temp Control Knob
Select the desired temperature.
Lower number side - More cool.
Higher number side - Less cool.
Note ; Temp Control number indications are for reference use only and do not
represent actual room temperatures.
4 Operation Mode Switch
REGULAR - The temp, control automatically controls cooling, but the fan runs
continuously whenever the air conditioner is in operation.
ECONOMY - The temp, control automatically controls cooling, but when the
room temperature reaches the temp, control preset point, both the
fan and compressor turn off. When the temp, control requires the
cooling operation to start again, both the fan and compressor turn
back on together.
Note : For fan only operation, Operation Mode Switch must be in “REGULAR”
position.
The fan will not run with the Main Control Knob set to FAN while the
operation mode switch is set to “ECONOMY”.
Caution : If the unit is turned OFF and immediately on again, an automatic protection device will prevent restart of
the compressor for approximately 3 minutes.
This is normal, leave the switch ON and operation will resume automatically when the protection delay
is completed.