Panasonic RAMSA WS-AT350 - Manual (Page 7)

WIRING CONNECTOR AND CABLE
TS (tip-sleeve) phone plug
1. Unscrew the plug cover.
2. Thread speaker cables through the plug cover.
3. Connect and solder the + (positive) polarity wire to
the tip of the plug.
4. Connect and solder the - (negative) polarity wire to
the sleeve of the plug.
5. Tighten cable with the clamp of the plug.
6. Fasten the plug cover.
Plug Cover 0 Sleeve
Speaker Cable
©Tip
AMP OUT Plug
+ Tip
- Sleeve
SPEAKON connector
Use SPEAKON connector (4-pole, NL4FC series, by
NEUTRIK AG) as followings.
® Unscrew the connector cap by rotating it
counterclockwise.
(D Slide the cable clamp out from the rear of the
connector.
(3) Push and separate the connector sleeve from the
terminal block.
® Pass the connector cap arid cable clamp over the
end of the cable.
® Loosen the clamping screws in the terminal block.
® Prepare and insert the wires into the terminals as
shown in the table.
@ Tighten the screws to secure the wires.
® For added security in portable applications,
soldering of the wires together with the terminals is
recommended.
® Assemble the terminal block and the connector
sleeve after matching the positions of the concave
and the convex.
® Match the convex position of the cable clamp to the
concave of the connector sleeve, then push the
cable clamp.
® Screw the connector cap.
Tamninat block
Cable clamp
AMP OUT SPEAKON
+ 1 +
- 1 -
(Not used) 2 +
(Not used) 2-
Push
@
Connector sleeve
Loosen screws.
®
®
®
Push Cable clamp
-
7
-