Panasonic QUICKDRAW MC-V5750 - Manual (Page 20)

lililí
A
WARNING
Electrical Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it>yourseif solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner will
not run. 1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panei.
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
Poor job of dirt
pickup. 1. Fuil or dogged dust bag.
2. Broken belt.
3. Clogged hose or nozzle.
4. Hose not inserted fully.
5. Worn agitator..
6. Hole in hose.
7. Dust cover improperty installed.
8. Belt not installed on motor shaft.
1. Change dust bag.
2. Replace belt.
3. Clean hose or nozzle area.
4. Insert hose.
5. Replace agitator.
6. Replace hose.
7. Properly install dust cover.
8. Install belt on nnotor shaft.
Dust escapes
the paper bag.
1. Bag improperly installed.
2. Bag torn.
1. Properly install bag.
2. Replace bag.
Light will
not work. 1. Burned out light bulb. 1. Replace light bulb.
-
2 0
-