Panasonic RECHARGEABLE SHAVER ES4011 - Manual (Page 7)

be overcharged.
Before traveling, charge it fully for 8
hours if you will not be taking the
charging adaptor with you.
For a better shave
Put a thin layer of shaving foam on
your face which works as a lubricant.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it may af­
fect the shaver’s performance, (f the
shaving head is clogged with foam,
simply rinse it under running water.
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (see fig.
3). Start out shaving by applying gen­
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di­
rection of your beard. You may gen­
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
Using the trimmer
Shaving longer, curly hairs under
the chin (see fig. 4)
Slide the trimmer switch up to the 1 st
position. This position makes the
trimmer an intercept cutter, cutting
tong hairs while the outer foil shaves
shorter hairs. Make sure that the trim­
mer is facing outward away from the
neck.
Trimming sideburns (see fig. 5)
Slide the trimmer switch up to the 2nd
position.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
(see fig. 6)
For cleanliness and convenience, we
recommend that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre­
venting odors or bacteria from devel­
oping, and maintain the cutting per­
formance.
With the outer foil in place, apply
some hand soap onto the outer foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the outer foil and clean it
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the outer
foil to dry completely.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver’s cut­
ting performance.
Replacing the outer foil
(see fig. 7)
Squeeze the outer foil release but­
tons and lift the outer foil upward to