Recording from compact discs, Press ^ eject on deck 2, and then insert a tape, Press reverse mode to select the reverse mode – Panasonic SCCH52 User Manual
Page 19: Press ^ open/close to load a cd, After the compact disc play finishes, To specify the tracks to be recorded, Recording from compact disc
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording from Compact Discs
L_"
J ^
<Aino nmiuto
<AUTOuvenu>
• You can use normal and chrome tapes.
• The leader tape must be wound up before-hand. (See page 17)
A EJECT
/■--------'
REVERSE MODE
o
^OPE№
CLOSE
Press ^ EJECT on deck 2,
and then insert a tape.
Close the holder.
Press REVERSE MODE to
select the reverse mode.
Z : One side will record, and then
the tape will stop automatically
at the end.
Z> : Both sides will record (forward
side reverse side), then the
tape will stop automatically at
the tape end.
CZ3 : Same as above (When you
press REC PAUSE. “ c Z 3 " will
be automatically switched over
to “ Z5”)-
Press ^ OPEN/CLOSE to load
a CD.
When you record from one disc;
Load a CD on the disc tray 1.
When you record from two or three
disc:
Load a disc from which you want to
record first on the disc tray 1, and in
order 2, 3.
Press ^ OPEN/CLOSE again to close
the tray.
A REC PAUSE
4
C_—.._3
Press REC PAUSE to put the
cassette deck into the record
ing standby mode.
“[RKTI" will light
5
Press
The recording will automatically start in
the (forward side) direction.
When CD play finishes, the cassette
deck enters the recording standby
condition.
After the compact disc play finishes:
When one disc is loaded:
The cassette deck will create a non-recorded passage of about 4
seconds, and then go into the recording standby state.
When two or three disc are loaded:
When there is a blank portion on the tape, the deck will automatically
start recording from the next compact disc.
To specify the tracks to be recorded:
(Steps 2-7 are from the remote control)
1. Follow steps 1 to 4,
2. Press PROGRAM.
3. Press DISC.
4. Press one of the disc buttons (DISC 1-3) to select the disc.
5. Press \« or to select the track to be edited.
6. Press PROGRAM.
7. Repeat steps 3-6 to program discs and tracks such that the
total playing time is less than the length of the tape (up to 24
tracks),
8. Press ► on the CD changer to start recording.
The recording will automatically start.
19