Panasonic KXF150 - Manual (Page 30)

Setting your logo
The logo is used to identify fax documents sent by your unit. It may consist of alphanumeric
letters and symbols.
Usually the logo is a company, division or personal name in an abbreviated form. Your
programmed logo will be printed on the top of each page transmitted from your unit.
Your printed logo can be up to 30 digits long.
To enter each character, select the correct code (2 digits) referring to the character code table
(see page 1-23), then program as follows.
1
2
3
C3E3E l 1I
I GHI 4 I ^ JKL 5 I I WHO 6 j
[ p u s 7 ] [ t u p S ] [ w s p 9 ]
[ -X-] [ g]
Press the PROGRAM button.
The display shows “P-
Press #, then press 02.
The display shows "P-F02 45 60 73”.
To obtain the character codes, press the HELP button.
Enter your logo by using the dial keypad.
The logo can be up to 30 characters long.
If you wish to check your programming, press the HELP
button.
When finished, press the SET button to store the
program into memory.
The display shows “P- ”.
Press the PROGRAM button to end the operation.
The display shows the current time.
1-22