Panasonic CQVA70EU - Manual (Page 32)

Installation Guide
■ Precautions
If possible, this equipment should be professionally installed. In case of difficulty, please consult with your
nearest professional installer.
1. This unit only operates in a 12-volt DC negative ground system.
2. Before performing installation and wiring, remove the negative (-) terminal of the battery. {See Note
below.)
Note:
Do not disconnect the negative battery terminal in vehicles equipped with trip or navigational computers. All
electronic memory settings previously registered will be lost. Take extra care to avoid causing short-circuits
when installing the unit.
3. Follow the wiring connection diagram carefully to avoid causing damage to the unit.
4. Insulate all exposed wires to prevent short-circuits.
5. Secure all loose wires after installing the unit.
6. Please carefully read the operating and installation instructions of any equipment connected to this unit.
■ Transportation bracket removal
Be sure to remove the transportation brackets before use (installation).
Use screws (M5 x 6 mm) with washers for installation.
Be careful not to lose any of these parts.
Transportation
■ Installation Hardware
(The supplied package contains the following installation hardware.)
No. Description Qty.
o Trim plate 1
o Mounting frame 1
€» Mounting spring 2
O Rubber pad 1
0 Mounting bolt (M5) 1
0
Flange nut (M6) 1
0 Washer assembling hex bolt (M5 x 10mm) 1
No. Description Qty.
o Washer assembling hex bolt (M6 x 20mm) 1
0 Stay 1
0 Binding-head screw (M5 x 6 mm) 2
0 Flat-head screw (M5 x 6 mm) 4
0 Spacer 2
0 Double-Faced adhesive tape 2
0 Magic tape 2
32
CQ-VA70EU