Seymour Midwest Application Squeegee(PK90134) - Manual

Application Squeegee
Assembly Instructions
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center hole on the
aluminum frame.
2. Position labeled gusset on bottom of adapter, as shown, and the other gusset
on top of the adapter. If unit comes with handle, gussets are interchangeable.
3. Insert the two longest bolts through the top gusset, the handle or adapter, and
the bottom gusset. Insert the two shortest bolts through the two remaining
holes.
4. Tighten all nuts being careful not to over tighten. Over tightening hardware
may result in crushing the handle, thereby compromising its strength.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and
workmanship. Products which have been abused or worn out from normal use are excluded from this
warranty. We reserve the right to replace or issue credit on an individual basis.
PK90134
01/21/15
Parts Shipped with Unit:
- Head
- Threaded handle adapter or aluminum handle (not pictured)
- Gusset brace (set of 2) – one gusset is labeled if unit comes with
threaded handle adapter)
- Bolt bag for brace
- Rubber blade (sold separately)
Rubber Blade Installation Instructions:
1. Loosen nuts (do not remove) on head and insert rubber blade.
2. Rest rubber blade on a hard, flat surface (as shown) and adjust blade to ensure
it is seated straight in the head and level with the flat surface.
3. Tighten nuts until rubber blade is secure, being careful not to over tighten.
NOTE: It is important when installing, reversing, or replacing the rubber blade that it
is installed straight.
To Reverse Rubber Blade:
1. Loosen the keps nuts and remove the rubber blade.
2. Reverse the rubber blade and reinstall, following the same instructions above.
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
FAX: 574-267-8508
www.seymourmidwest.com
Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
Tools Needed for Assembly:
- 7/16” wrench (two)