Seymour Midwest Aquatic Weed Eradicator [AWE](PK90107) - Manual

Fig 4 Fig 3 Fig 5
Fig 6
Aquatic Weed Eradicator
Assembly Instructions
Blade Assembly Instructions:
1. Lay the 2 serrated steel blades (A) with the WARNING label side face down and
arrange the arrows so that they are pointing towards each other (figure 1).
2. Place the “L” shaped stiffener bar (B) over the 2 serrated blades (A) with the
arrow pointing away from you (figure 2).
3. Align the 4 holes.
4. From the underside, insert 2 of the short bolts (D) in the 2 outside holes, up
through the bar. Place loc nuts (E) on the bolts and finger tighten (figure 3).
5. Place the adapter plate (C) on the stiffener bar (B), aligning the 2 holes of the
plate (C) with the 2 center holes on the stiffener bar (B) (figure 4).
6. From the underside, insert 2 short bolts (D) in the 2 center holes of the steel
serrated blade (A), up through the “L” shaped stiffener bar (B) and through the
adapter plate (C) (figure 5).
7. Place loc nuts (E) on the bolts (D) and use 2 wrenches to tighten.
REQUIRES TWO 7/16” WRENCHES AND GLOVES FOR HANDLING THE STEEL
SERRATED BLADES
Gusset Brace Instructions:
1. Slide the label end of the handle (label facing up) (G) over the center hole on the adapter plate (C) and align holes.
2. Position 1 gusset brace (F) on the bottom of the handle (G) and the other gusset brace (F) on top of the handle
(figure 7).
3. Insert 2 long bolts (H) through the top gusset brace (F), the handle (G), and the bottom gusset brace (F).
4. Insert 2 short bolts (D) through the remaining holes passing through the gusset brace (F) and adapter plate (C).
5. Place loc nuts (E) on bolts and tighten using two 7/16” wrenches.
DO NOT OVER TIGHTEN. OVERTIGHTENING MAY RESULT IN CRUSHING THE HANDLE AND COMPROMISING ITS
STRENGTH.
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
FAX: 574-267-8508
www.seymourmidwest.com
Warsaw, IN 46580
Blade Components:
A – Steel Serrated Blades (2)
B – “L” Shaped Stiffener Bar
C – Adapter Plate
D – Short Bolts (5/8”) (4)
E – Nylon Loc Nuts (4)
Gusset Brace Components:
F – Gusset Brace (2)
G – 66” Labeled Handle (no grip)
H – Long Bolts (1 3/4”) (2)
D – Short Bolts (5/8”) (2)
E – Nylon Loc Nuts (4)
Fig 2
Fig 7
INSTRUCTIONS CONTINUED ON REVERSE SIDE
Fig 1