Seymour Midwest CAM® Gauge Rake(PK90090) User Manual

Gauge rake, Assembly instructions, Replacement parts list

Advertising
background image

Mailing Address:

Shipping Address:

PO Box 1674

2666 S Country Club Rd

Warsaw, IN 46581-1674

Phone: 8

44-SEYMOUR

FAX: 574-267-8508
www.

seymourmidwest.com

Warsaw, IN 46580

CAM

®

Gauge Rake

Assembly Instructions

Tools Needed for Assembly:

ƒ

7/16” wrench (two)

Parts Shipped with Unit:

ƒ

Head

assembly

ƒ

Threaded handle adapter or aluminum handle (not pictured)

ƒ

Gusset brace (set of 2) – one gusset is labeled

ƒ

Bolt bag for braces
CAM

®

sets are ordered separately and may or may not be

shipped with this unit

Gusset Brace Instructions:

1. Slide slotted handle or threaded handle adapter over the center

hole on the aluminum frame.

2. Position labeled gusset on bottom of handle/adapter, and the other

gusset on top of the handle/adapter as shown.

3. Insert the two longest bolts through the top gusset, the

handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.

4. Tighten all nuts, being careful not to over-tighten. Over-tightening

hardware may result in crushing the handle, thereby compromising
its strength.

CAM

®

Assembly:

1. Remove the wing nut and loc washer on each end of the head

assembly.

2. Place the CAM

®

on the head, as shown, followed by the loc washer.

Secure with wing nut. Do the same on the opposite end of the
head.

3. Make sure CAM

®

striking surface is in line with screed edge, as

pictured.

FULL WARRANTY

All

Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.

Products which have been abused or worn out from normal use are excluded from this warranty.

We reserve the right to replace or issue credit on an individual basis.

REPLACEMENT PARTS LIST

See Reverse Side

PK90090

1/14/15

Advertising