Seymour Midwest Concrete Placer(PK90179) - Manual

Concrete Placer
Assembly Instructions
Tools Needed for Assembly:
- 7/16” wrench (two)
Parts Shipped with Unit:
- Head
- Handle with T-adapter: aluminum, fiberglass or wood (not shown)
- Bolt Bag for connecting head to handle
- Optional: Hook Hardware Kit, including spare hook
For Concrete Placer Tool without Optional Hook:
NOTE: The T-adapter plate, which is mounted on the handle, is
welded at an angle. You may try different positions to determine the
angle variation you desire.
1. Align holes on end of handle with EITHER the top or bottom pair of
holes
on placer head.
2. Insert two shortest bolts and use wrenches to tighten nuts.
For Concrete Placer Tool with Optional Hook:
NOTE: The T-adapter plate, which is mounted on the handle, is
welded at an angle. You may try different positions to determine the
angle variation you desire.
1. Position head so teardrop edge of head is on top.
2. Align T-adapter with either pair of holes on head.
3. Align holes of hook on head (as shown) and insert appropriate bolts.
4. Use wrenches to tighten all hardware.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and
workmanship. Products which have been abused or worn out from normal use are excluded from this
warranty. We reserve the right to replace or issue credit on an individual basis.
REPLACEMENT PARTS LIST
See Reverse Side PK90179
1/21/15
Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
FAX: 574-267-8508
www.seymourmidwest.com
Warsaw, IN 46580