Seymour Midwest Measuring Wheel Arm Alignment Instructions (PK30003) - Manual

MP (Metal Professional) counter alignment
Seymour Midwest LLC | 1.844.SEYMOUR | www.seymourmidwest.com | PO Box 1674 Warsaw, IN 46581
Locate the flapper.
(If you’re replacing the flapper, undo the
A screw and put on the new flapper.
Replace screw “A”.)
Adjust the angle of the flapper if neces-
sary. Loosen the B screw and adjust the
angle of the flapper to 30º . If you look
directly at the counter from the side,
align the flapper so that you can just see
the cicle (C) on the counter box. It is not
red on your counter, it is black.
Test it by rotating the wheel slowly. The
counter should tick off a foot when the
pin is about 1/4” from the bottom tip of
the flapper.
30º
A
B
MP counter close-up
C
measuring wheels
Counter not reading right?
Check your flapper alignment!