Seymour Midwest Seal Coat Squeegee(PK90292) - Manual

Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
Tools Needed for Assembly
-7/16” wrench (two)
Parts Shipped with Unit:
-Head
-Aluminum handle (not shown)
-Wrap-around brace (set of 2)
-Bolt bag for brace
-Rubber blade (one edge square, one edge either rounded or
slanted)
Seal Coat Squeegee
Assembly Instructions
Rubber Blade Installation Instructions:
1. Loosen nuts (do not remove) on head and insert square edge of rubber
blade.
2. Rest rounded or slanted edge of rubber blade on a hard, flat surface (as
shown) and adjust blade to ensure the square edge is seated straight in the
head and level with the flat surface.
3. Tighten nuts until rubber blade is secure, being careful not to over tighten.
NOTE: It is important when installing or replacing the rubber blade that it be
installed straight.
Handle & Brace Assembly:
1. Slide slotted end of handle over center hole on aluminum head.
2. Align holes and insert middle size bolt.
3. Align holes of flat end of braces with holes on head, as shown, and insert
the two shortest bolts and nuts (do not tighten nuts until step 5)
4. Align holes of wrap-around end of braces with the handle, as shown, and
insert the longest bolt and nut.
5. Tighten all loc nuts on bolts. Use wrenches to tighten, being careful not to
over tighten. Over tightening may result in crushing the handle, thereby
compromising its strength.
REPLACEMENT PARTS LIST
See Reverse Side
PK90292
01/21/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com