Tire-SafeGuard Tire Pressure Monitoring System TPM-V - Manual (Page 4)

July 2006 TPM-V Installation Manual 3
a) Elevate vehicle to a proper working height.
b) Deflate the tires and remove the original valve stems.
c) Match sensor number with the wheel location as showed below. Remove the sensor stem
Cap (6).
d) Adjust Body (2) to Stem (3) angle and then tighten Screw (1). Detach Sleeve (5) by inserting
the Steel Pin (TPM-SP) to the hole on the Stem base and holding the Pin with one hand,
and then using the other hand to twist the Sleeve counterclockwise - detaching it from the
Stem.
e) Press the sidewall of the tire to make working space. Put the sensor inside the tire with the
Stem coming out through the valve hole. Put the Washer (4) and the Sleeve back on the
sensor Stem.
f) Tighten the Sleeve with a socket wrench (use the Steel Pin to hold the Stem base steady).
The recommended torque is 12 ft-pound (16 Nm). Do not over tighten. Over tightening may
damage to the sensor or cause air to leak. Put the Cap back on the sensor Stem.
g) Reset tire sidewall, making sure the tire bead does not damage the sensor.
h) Inflate the tires to proper pressure.
Note: The system is pre-programmed with the sensors in the package.
Thus after sensor installation the user does not need to perform
any set up procedures - the system should be working properly.
The setup procedure is described in the Operations Manual and
is for re-programming the system after tire change or rotation.