Tire-SafeGuard TPM-W - Manual (Page 4)

Mar. 2006 TPM-W Operator’s Manual 6
5. Retrain System after Tire Change and/or Rotation
Alter the tires have been changed and/or rotated the system must be
retrained to display the correct tire locations, as follows:
5.1 Retrain System for All Tires
• Press and hold down the Setup Button. Turn on vehicle power.
After 6 seconds the system enters the Manual Setup screen of
the Tire Setup Select Mode. Release the Setup Button.
• Pressing the Control Button at this point will change the screen
to the Auto-Setup mode, which shows two extra letters: AU.
Pressing the Control Button again goes back to the Manual
Setup screen.
Manual Setup Screen:
Auto-Setup Screen:
• Press the Setup Button at a screen selects that particular setup
mode; the #1 tire indicator starts blinking.
• Manual Setup Steps -
¾ Release 3 PSI or more of air from the #1 tire. This triggers its
sensor to send out a signal. Upon receiving the signal, the
system sets up this tire as the #1 tire location. The system
then moves on to the #2 tire.
Setup Button
Control Button
Mar. 2006 TPM-W Operator’s Manual 7
¾ Repeat the above step for the remaining tires (The setup order
must always be from tire #1, #2, …, to the last tire). After
successfully retraining the last tire the system exits the
Manual
Setup mode automatically.
¾ A simply way of retraining is: put the system to retraining
mode, follow the setup order and release air from each tire for
20 seconds without needing to look at the display. After
working on the last tire the retraining will be completed.
¾ Refill tires to the proper air pressure.
¾ Turning vehicle power off before finishing always cancels the
setup.
• Auto-Setup -
¾ The Auto-Setup mode is specially developed to support our
external valve-stem mounted sensors. Using this mode to set
up internal sensors would lead to incorrect sensor assignment
to a wrong tire location. Therefore please use
Manual Setup
for the rim mounted sensor.
5.2 Retrain System for Some Tires
• To retrain system for tire rotation or replacement with less than
all the tires, get into the Manual Setup screen as described
above, press the Control Button to move the blinking icon to the
desire tire location, and then release the associated tire air as
described earlier to set it up.
• Note that each skipped tire will retain its previous location
assignment.
• If there are more tire setup then press the Control Button again
for moving the blinking icon to the next desire tire location, and
then repeat set up procedure.
• Press the Control Button passing the last tire icon to exit the
setup and save the new setting.
• Turning vehicle power off before finish always cancels the setup.