MagnaFlow DODGE CALIBER Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) Begin removing the OEM exhaust by
loosening the clamp just after the catalytic converter.
Then disengage the welded hangers from the rubber
insulators and remove the system from the vehicle.
Do not discard or damage the OEM fasteners or
rubber insulators, as they will be reused to mount the
new system.
Step 2: Begin installing the new system starting with
the front resonator assembly. Using a supplied 3.00"
clamp, secure the assembly to the converter outlet
pipe, and engage the welded hanger into the rubber
insulator. Leave all clamps and fasteners loose for
final adjustment of the complete system. Continue
installing the rest of the system in a similar manner.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align thr pipes and prevent leaks
(approximately 40ft. lbs.). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
For 16758
2007- Dodge Caliber SRT-4
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Dec 14, 2009
Rev: 000
3X 3.00" CLAMP
FRONT RESONATOR ASSEMBLY
MID PIPE
MUFFLER ASSEMBLY