Amplifier power harness connections – Carson SA-430-83FX User Manual

Page 5

Advertising
background image

TB0334B

Page 5 of 9

10/18/03

AMPLIFIER ELECTRICAL CONNECTIONS

Disconnect vehicle battery before making the following electrical connections.

Electrical connections to the amplifier are made using the wiring harness supplied. If the amplifier needs service the
connector can be easily removed without unwiring the harness. The power supply for the amplifier must be capable of
delivering peak currents up to 50 amps for adequate short circuit protection and reliable operation. The preferred
source is directly at the vehicle battery. A fuse on the unit protects from overload.

Wire Size and Termination - The diagram shows the minimum wire size used for each connection. If the wire is
longer than 10 ft. use the next larger wire size. Use only high quality crimp connectors for installation on the vehicle.

Negative Connection (Black) - Both leads must be used. Connect to negative battery connector or high current
buss.

Positive Connection (Red) - Both leads must be used. Connect to positive battery connector or high current buss.
A power relay may be used.

Speaker Connection (Orange) - Both leads must be used. Connect 1 lead to each terminal or lead of the speaker.
When used with 2 speakers connect each orange lead to both speaker terminals or leads (parallel circuit). Observe
polarity (phasing) when connecting 2 speakers.

Control Connection (White) - Connect to white lead from control head. Route this lead away from radio transmitter
antenna lead to prevent RF interference being fed to the siren amplifier.

Optional Radio Input Connection (Blue) - Connect 1 lead to each terminal of the radio speaker or output connector.
The input is isolated and polarity is not important. May need to set RADIO VOLUME ADJUST on side of unit.


AMPLIFIER POWER

HARNESS CONNECTIONS

(2)

#18 AWG ORG

(#16

-

2 SPKR)

2

-

SPKR

-

Connect for

same phase (+ to +)

#14 AWG BLK

Use both leads

Extend with #12

#14 AWG RED

Use both leads

Extend with #12

-

BAT

+

CP3877-1

CABLE

RADIO

HORN

MAN

WAIL

YELP

PHASER

SIREN

PA

VOL

ON

POWER

GRN (AUX)

YEL (DASH LIGHTS)

BLK (-VDC)

RED (+VDC)

BLK TO -VDC

RED TO +VDC

20AMP FUSE
AUTOMOTIVE TYPE

RADIO VOLUME
ADJUST

BLU TO TWO WAY

RADIO SPEAKER

WHT

CONTROL

CONTROL HEAD

AMPLIFIER

(CP3889
CABLE)

(CP3040 CABLE)

- ORG/BLK TO SPKR -

+ ORG TO SPKR +

(CP3877-1 CABLE)

Advertising
This manual is related to the following products: