Cable Electronics CELABS HSW88C - Manual (Page 9)

DIP SWITCH Definition of IR Earphone Jack
Supported IR Data Format
Data Format Suitable Not
Recommended
NEC
RC5
TOSHIBA MICOM
CODE
GRUNDIG CODE
SONY 12 BIT CODE
SONY 15 BIT CODE
SONY 20 BIT CODE
RCA CODE
RCM CODE
MATSUSHITA CODE
MITSUBISHI CODE
ZENITH CODE
JVC CODE
M50560-001P
MN6125H
MN6125L
MN6014_C5D7
MN6014-C6D6
MC14457P
LC7464(AHEA)
GEMINI_CM
1 = IR signal (38KHz)
2 = Grounding
1 = Power
2 = IR signal (38KHz)
3 - Grounding
The IR extension cables are standard market configuration.
You can buy From CE labs if necessary for replacement use.
SW1-SW8 for EDID/Audio
Note:
1. If the HDTV shows video but without audio, please try to set
audio mode to stereo.
2. Factory default setting of [SW1]-[SW8] is pin#1-OFF[ ] &
pin#2- OFF[ ] for 1080p with stereo.
3. If you encounter any unsolved audio/video output problem
during system installation, please turn any [SW1]-[SW8] to
pin#1-OFF[ ] & pin#2-ON[ ] for safe mode to enforce the
most compatible 720p stereo output for system check.
However, the safe mode cannot be initiated if your HDMI
source is set to enforce 1080p output. In this case, please
reconfigure your HDMI source to all resolution output for
troubleshooting.
4. Bypass means the matrix will maintain playing the original
format of HDMI signals in video and perhaps audio. By
setting at this mode, the users may encounter compatibility
issue among different kinds of HDMI sources and displays. If
you cannot get the audio and/or video output normally at
the system installation, please change the DIP switch setting
to default mode or even safe mode to verify the
functionality of the device.
5. To learn the EDID of HDMI display for respective HDMI source
devices, please see the [EDID Learning] section in the next
page for more detail information.
DIP Switch Position
Pin#1 Pin#2
Video Audio Description
OFF [ ] OFF [ ]
Up to
1080p
Stereo 1
Default Mode 2 – Up to 1080p & stereo audio output for
most HDTVs
OFF [ ] ON [ ]
Up to
720p /
1080i
Stereo
Safe Mode 3 – Enforce the system output at 720p/1080i
video and stereo audio for basic compatibility among
HDTVs
ON [ ] OFF [ ] Bypass 4 Bypass 4
EDID Learning Mode 5 – for learning EDID from the
display while playing any received HDMI audio format
ON [ ] ON [ ] Bypass Stereo
EDID Learning & Stereo Mode 5 – for learning EDID from
the display while enforcing stereo output if any HDTV
cannot play surround sound normally