MagnaFlow DODGE DIESEL CUMMINS, DUAL SYSTEM Black Series Kit Diesel PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions
before installation)
To remove the OEM system,
you will need to cut the tailpipe just behind the OEM
muffler. Working front to rear remove the OEM
system rearward of the DPF. Disengage the welded
hangers from the rubber insulators and remove the
sensor wire bracket and undo all attaching clamps. Do
not damage or discard the OEM rubber insulators as
they will be reused to mount the new system.
Step 2: Begin by attaching the Inlet Pipe Assy to the
outlet of the DPF using a suppled 4.00" clamp,
making sure to index the slot with the pin on the OEM
pipe and by fitting the hangers into the OEM rubber
insulators (all clamps are to be left loose for final
adjustment of the system). Install the Mid Pipe,
Y-Pipe and Tail Pipe Assembles in a similar fashion
using the supplied 4.00/3.50" clamps and fitting the
hangers into rubber insulators. Finish by re-attaching
the sensor wire bracket to the Inlet Pipe Assembly.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and clearance
of frame & bodywork. (MAGNAFLOW recommends
at least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
17045
2013 Dodge Ram 6.7L 2500HD/3500 6.7L BS
Warning : When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
07/30/13
Rev: 000
Mid Pipe
[3] 4.00"
Clamps
Inlet Pipe
Assy
Y-Pipe
Assy
Tail Pipe
Assy
[2] 3.50"
Clamps