English, Distorted audio, Amplifier fuse keeps blowing – Clarion DPX2250 User Manual

Page 22: Whining noise when engine on

Advertising
background image

22

APX/DPX Amplifiers

English

Amplifier shuts down after playing for a period of time

Thermal protection circuits are shutting the amplifier off: Check the location for

adequate ventilation. Relocate amplifier as required. Consult an authorized
Clarion audio dealer.

Distorted audio

Gain is not properly set properly: review the instructions for setting the gain.
Speaker cones are damaged: inspect each speaker cone for signs of damage,

such as a frozen cone, burnt smell, separated or ripped surround or separated
spider.

Amplifier fuse keeps blowing

Incorrect wiring or short circuit: review the installation and check all wiring

connections.

Amplifier being driven too hard: Turn down the

volume, gain or bass boost.

Undersized or faulty fuse installed: Replace the

amplifier fuse with the same rating fuse as the one
that shipped with the unit.

Note:

The DPX11500 ships with a 200 Amp, ANL-type
fuse; mount it external to the unit, near the battery.

Whining noise when engine on

RCA cables too close to the power wire: Separate RCA and power cables.

Ground loops are caused by a mismatch in the ground potential (voltage) between
two sources. Current flows through the shield of the RCA cable and is quickly
picked up by the amplifier. There are several ways to solve this problem:

• Re-ground the amplifier to a more electrically conductive location.
• Re-ground the head unit to a more electrically conductive location.
• Run a ground wire from the head unit to the amplifier ground.
• Upgrade or replace the ground wire on the battery and alternator.
• Run a ground cable from the negative terminal of the battery to the amplifier.
• Wire the entire audio system using a single connection point to the chassis.

Induced noise: Relocate components away from electrical noise sources:

• Engine control computers
• ABS brake control modules.

Fuse rating table

Model

Fuse rating

APX2180

30 Amp

APX4360

50 Amp

DPX2250

50 Amp

DPX1800

90 Amp

DPX11500

200 Amp

APX-DPXOwnersManual.pmd

2006-03-14, 21:47

22

Advertising
This manual is related to the following products: