MagnaFlow DODGE DIESEL CUMMINS, 4in. SYSTEM AL Custom Build Pipe Kit Diesel PERF. EXHAUST User Manual
MagnaFlow For the car
Step 1: (Carefully read all instructions before
installation) To remove the OEM exhaust
system, you will need to loosen or remove the
clamps that fasten the system together,
including the V-band clamp at the turbocharger.
You can then disengage any welded hangers
from the OEM rubber insulators and extract the
system from the vehicle.
Step 2: Before installing the new downpipe,
you will need to temporarily remove the hanger
bracket on the bellhousing that attaches to the
downpipe hanger as shown in Fig.1. Install the
new downpipe by fitting the OEM hanger
bracket onto the downpipes welded hanger,
then remount the hanger bracket and
turbocharger V-band clamp. Leave all clamps
and fasteners loose for final adjustment of the
complete system. CC/SB and EC/LB trucks will
use the 42.0" extension pipe. CC/LB and
MC/SB trucks will use the 28.0" extension pipe
between the 30.0" and 42.0" extension pipes.
Install the required Extension Pipes, Over Axle
Pipe and Tailpipe by fitting the welded hangers
into the OEM rubber insulators, and by
fastening the pipes together using the supplied
4.0" band clamps.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
18919
2004.5 - 2007 Dodge Diesel 5.9L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 16, 2012
Rev: 000
DOWNPIPE
42" PIPE
28" PIPE
OVER-AXLE PIPE
TAIL PIPE
30" PIPE
(5) 4.00" Clamps