360 Systems 2470SD Time Delay - Manual (Page 8)

8 • Broadcast Time Delay
Installation
Unpacking
Your Time Delay has been carefully inspected and calibrated before shipment to allow immediate
operation upon installation. Check all items for signs of visible damage which may have occurred
during shipment. If any item is damaged, contact the carrier to file a claim.
Keep the packing materials in the event that a unit must be shipped by you. If the original
packaging is not available, make sure that the following criteria are met:
• Packaging must be able to withstand the product weight.
• Product must be held firmly within the package.
• There must be at least two inches (50mm) of space between the product and outer container.
• The corners of the product must be protected.
Package Contents
Confirm that all items on the packing list have been received. Contact 360 Systems if any item is
missing.
Broadcast Time Delay
Keyboard
2-Button Scroll Mouse.
Software CD-ROM backup copy
Rack Mount Hardware Kit
Operations Manual
Power cord
Warranty Card
The Time Delay is not shipped with a video monitor. Select a VESA-compliant CRT or LCD monitor
capable of a refresh rate of at least 75 Hz. Note that the Time Delay may not start correctly if an
unsuitable monitor is connected.
If you own more than one Time Delay, it may be appropriate to use a single keyboard, monitor, and
mouse with a KVM switch to select between servers. Not all KVM switching systems are compatible.
The KVM switch must supply an active signal to the Time Delay at all times, even when switched away
from it. When first powering up the Time Delay, use only the supplied keyboard and mouse directly
connected. Then test the KVM switch system that will be used thoroughly before installation is
completed. NOTE: If the mouse and keyboard connections are interchanged, the Time Delay may not
boot up properly. Be especially careful about this when using extender cables.
Rack Mounting
Note: If you plan to use digital audio, be sure to change the configuration of the Analog/Digital
Audio Jumpers inside the unit before mounting the Time Delay in a rack. The jumpers are factory
set to the Analog audio position. For more information about changing the jumpers, see
Analog/Digital Audio Selection on page 34.