Adaptive Technologies LTMB24 - 1x2 User Manual
Page 2
© 2008 ATM FLY-WARE Signal Hill, CA 90755 USA (562) 424-1100
REV01 –Revised illustration and steps of installation-022510
Step 4:
Check all connections before suspending the speaker cluster.
Step 5: Connecting the 2
nd
Tier of LTMB24 loudspeaker
Repeat step 1 and 2 for the 2
nd
tier of speaker (Figure 1)
Step 6:
Lift up the first tier of LTMB24 loudspeakers and place it on
top of the second tier of loudspeakers. Align the frames so
that the top and bottom frame’s center ½” dia. holes match
up.
Step 7: Install LTMB24-ROD-KT (sold separately)
Securely join the top and bottom tier by bolting the frames
together using a ½” threaded rod, flat washers and jam nuts
(LTMB24-ROD-KT sold separately). Insert the threaded rod
from the hole of the top frame and into the bottom frame. Use
the four corner hole. Apply lock-tite liquid solution on the nuts
then secure both ends of the threaded rods with flat washer
and two jam nuts (two jam nuts per end). Tighten nuts
permanently until frame and loudspeakers are tightly secured
(Figure 3 and 4).
Figure 2
Figure 4
Figure 3