Adaptive Technologies MM-120-BTM - Manual

© 2013 Allen Products Co., Inc. Signal Hill, CA 90755 (562) 424-1100 REV.00-102413
Four Mounting Points Three Mounting points
Figure 1 (Mounting Options)
MM-120-BTM
Universal Wall Mount Installation Instructions
The MultiMount™ MM-120-BTM wall mounting kit mounts and
positions loudspeakers with bottom hole patterns weighing, up to 120
lbs/55 kg to most vertical structures. The MM-120-BTM simplifies and
speeds up installations while offering a very versatile range of aiming.
Warning:
Mounting and/or rigging equipment requires experienced
professionals.
Improperly installed loudspeakers can result in property damage,
personal injury, death and/or liability to the installing contractor.
Note to installing contractor:
Due to the wide variety of wall structures, materials and mounting
methods, these instructions assume that the installing contractor will
exercise proper judgment in selecting the mounting area and
hardware.
As a guide, the installation, when complete should be capable of
supporting 5 to 10 times the actual applied load. Also, always use a
back up safety system such as a safety cable.
To assure a trouble free installation, read through and follow these
instructions carefully before beginning. If you have doubts about the
integrity of the structure you are mounting to or you are not
sure about the proper hardware to use, consult a structural
and/or hardware specialist.
Be sure that all of the following items are included in
this kit before proceeding:
Item #: Qty
Description
1. 1 pc. Wall mounting plate
2. 1 pc. Speaker adapter assembly
3. 1 pc. Extension arm (attached)
Step 1:
If the optional Stud Brace Plate is selected to bridge the
MultiMount-120-BTM between two structural wall studs,
install this in the desired area now then bolt MultiMount-120-
BTM directly to the bridge (Figure 2).
Step 2:
Detach the wall mounting plate from the support arm by
removing the bolt, washers and nut securing the support
arm to the wall mounting plate. Place the mounting plate over the signal wire exit and attach it to the wall with the appropriate
hardware for the application. If in doubt, consult a local hardware specialist (Figure 3).